HOW TO REPAIR A LEAKING ROOF

The roof is at the top of any homeowner’s maintenance list, and they’re likely to suffer a lot of wear and tear. Fortunately, you can fix minor issues without the help of a professional. Here are some common ones that will interest you: 

 

Fixing Asphalt Shingles

1 - Check for roof damage above water marks on the ceiling. Alternatively, wait until it rains so you can identify the location of the leak.

 

If you haven’t already tracked down the leak, trace the water damage inside your home. If you have an attic, head up there with a flashlight, and look for water stains or mold. 

Note the location of any evidence you find, then inspect the corresponding spot on the exterior of your home. Be sure to stay safe throughout these steps. 

 

If your roof is slanted, inspect areas that are higher than where you’ve found interior evidence of a leak. Water enters the leak then, due to gravity, it gets into the attic at a point farther down the roof’s pitch.

  • If you have trouble, run a hose for 1 to 2 minutes along different sections of the roof. Have a person inside alert you when they spot water.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2 - Inspect your roof for widespread wear and tear. Look for curled, cracked, or missing shingles at the leak site, and evaluate your roof’s overall condition. 

 

See if there are numerous failing or missing shingles, wide gaps where roofing material meets vents or a chimney, and other signs of widespread wear and tear.

 

  • Repairing 1 or 2 shingles and resealing minor gaps are relatively easy fixes. 

However, patches of failing shingles and widespread wear are signs that your roof needs to be replaced, especially if it’s over 20 years old.

 

  • Additionally, if you find widespread rot or mold on your roof boards or trusses inside your attic, you might have structural issues that require professional help, if you are in the Washington State area, Prosperity Roofing is Highly Recommended.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3 - Straighten and reattach curled shingles. Over time, the corners of asphalt shingles often begin to curl. 

 

Carefully smooth out any curled-back shingles, then use a caulking gun to apply a dab of roof sealant under the raised corners. 

 

Press the shingle down, then use a trowel to cover the shingle’s edges with roof cement.

  • Shingles are pliable in warm temperatures. Since they’re brittle in colder weather, you might need to soften a curled shingle with a blow dryer.

WARNING: Don’t use a heat torch or any heat source more intense than a blow dryer, or you’ll damage the shingle.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4 - Repair a clean crack with roof sealant. There’s no need to replace a shingle with a clean tear. Instead, apply a thick bead of roof sealant under the crack with a caulking gun. 

Press the shingle down, then apply another bead of sealant over the crack. Use a putty knife to spread the top bead over both edges of the crack.

  • To disguise your repair, look around the roof and in the gutter for accumulations of asphalt granules. 

 

  • Collect a small amount, then sprinkle them in the sealant to match its color to your shingles.

 

5 - Replace broken or missing shingles. If part or all of a shingle is missing, head to the hardware store to find a matching replacement. 

 

To remove the broken shingle, carefully lift the edges of the shingle above it with a pry bar. Use a hammer to remove the nails at the broken shingle’s 4 corners, slide it out, then scrape the area beneath to remove any leftover roofing cement.

 

  • If necessary, use a blow dryer to make the surrounding shingles more pliable. After removing the old shingle, use a utility knife to round the back corners of the new shingle.

 

Slide the new shingle into place, gently lift the shingle above, and drive 1 1⁄4 inch (3.2 cm) galvanized roofing nails into the new shingle’s corners. Finally, use a trowel to apply roof cement over the nail heads and edges of the new shingle.

If you live in Washington State and need any Roofing or Construction assistance contact the right company to get the job done!

Contact Prosperity Roofing by clicking the button below!

Fixing Roofs
Fixing the Roof
Replacing Tiles

(Contact Prosperity Roofing in the Washington State area! 425-588-1990)

(Contact Prosperity Roofing in the Washington State area! 425-588-1990)

(Contact Prosperity Roofing in the Washington State area! 425-588-1990)